| |
Molybdenum Disulfide
Molybdenum Disulfide Coatings
Moly coatings are a combination of molybdenum disulfide lubricant and high performance resins. Moly coatings are thermally cured and thoroughly bonded to the base metal of the coated part.
Contact us to see if a Mobyldenum Disulfide coating is right for your application.
Molybdenum Disulfide Coating
Disulfide (WS2) or Molybdenum Disulfide Coating is an extremely slick, dry film lubricant coating. WS2 has an extremely low coefficient of friction of 0.03 -- lower than that of Teflon, Graphite, or Molybdenum Disulfide (MoS2). The film is remarkably durable compared to many other lubricant materials and can withstand tremendously high loads of over 300,000 psi! WS2 has unsurpassed performance properties for lubricity, non-stick, low drag, wear life, and load rating.
WS2 is an excellent release material for plastic molds, extrusion dies, and other release applications.
WS2 can eliminate the need for liquid lubricants or can be used with petrochemical oils, greases, synthetic oils, silicone lubricants, and hydraulic fluids. It has an affinity for lubricants and maintains a hydrodynamic layer. It helps to hold oils or greases on the surface, increasing lubrication even more.
At only 0.5 microns (0.000020”) thick, the coating can be applied to high-precision parts without tolerance problems.
WS2 is also a fairly inert and non-toxic material that has been used in medical device and food processing applications.
WS2 is applied to customer substrates by an ambient temperature high velocity process. It will not anneal or warp substrate materials.
WS2 can be used alone, or in combination with our PVD hard coatings for even greater durability!
About Ws2 Coatings
- Lubricity—lowest coefficient of friction available in a solid material!
- Friction coefficient of 0.03 Dynamic, 0.07 Static
- Excellent release properties. Non-stick.
- Non-toxic
- Prevent galling, seizing or cold-welding
- Can be used at loads of over 300,000 psi!
- Withstands high temperatures
- Extremely thin 1/2 micron coating thickness.
- Bonded to the substrate without the use of binders, unlike many powdered lubricants
- Cannot chip, peel or flake
- Ultra thin--suitable for high precision components.
- WS2 can eliminate the need for liquid lubricants
- Can be used with oils and greases. It has an affinity for lubricants and maintains a hydrodynamic layer.
- BryCoat uses proprietary technology to apply WS2 coatings to customer substrate parts.
Molybdenum Disulfide Coating Statistics |
Load Capacity (ASTM 2625 B) |
250,000 psi |
Wear life (ASTM 2625 A) |
250 min. |
Salt Spray Resistance (ASTM B117) |
500 hrs. |
Coefficient of Friction (ASTM D1894) |
.19 static
.16 kinetic |
Abrasion resistance (mil STD 141A) |
10,000 cycles/mil |
Thickness |
.001" - .003" |
Use Temperature |
400°F max * |
|
.gif)
.gif)
